Metal Substrates Cyanoacrylate Adhesive / Cyanoacrylate Based
Ethyl Cyanoacrylate Raw Glue
Color: Clear to Hazy colorless liquid
Container: Plastic bucket
Glue Type: Instant adhesive
Net weight: 20kg / 25kg
Ethyl Cyanoacrylate Adhesive Raw Glue For Metal possesses high
strength when bonding metal materials or metal to rubber materials.
They perform better as compared to traditional ethyl cyanoacrylate
products.Metal Ethy Cyanoacrylate Adhesive has been specially
formulated to achieve the strongest possible bond between
well-mated metal substrates. This metal type cyanoacrylate adhesive
is one-component, solvent-free which is very good for enviroment
|Color||Clear to Hazy colorless liquid|
|Specific Gravity @ 25ºC||1.1|
|Refractive Index (n D 20)||1.439|
|Vapor Pressure (hPa)||< 1|
|Viscosity (cP) ,25℃||900 – 1600|
|Steel to Steel||20 – 70 seconds|
|Stainless Steel||30 – 60 seconds|
|Aluminum||5 – 20 seconds|
|Zinc plated||60 – 150 seconds|
|ABS to ABS||15 – 50 seconds|
|ABS to NBR||5 – 10 seconds|
|NBR to NBR||5 – 10 seconds|
|Polycarbonate||15 – 50 seconds|
DIRECTIONS FOR USE:
1. Make sure the surfaces to be bonded are clean and dry
(preferable to solvent-wipe plastics, glass, and rubber, and to
2.Dispense a drop or drops to one surface only. Apply only enough
to leave a thin film after compression.
3.Press parts together and hold firmly for a few seconds. Good
contact is essential. An adequate bond develops in less than one
minute. (Maximum strength is achieved in 24 to 48
4.Wipe off excess Solvent-free Ethyl Cyanoacrylate adhesive from
the top of the container and recap if left uncapped, may
deteriorate by contamination from moisture in the air.
Keep products in the unopened container in a cool and dry location.
Best when stored at 2 to 8ºC. Temperatures less than 2ºC can
adversely affect product properties. Do Not Freeze. Keep container
tightly closed until ready for use.
Material removed from containers may be contaminated during use. Do
not pour back any product to the original container. Misuse of
product will void all warrantees.
1.Use with proper ventilation. Avoid contact with skin and eyes.
2.If contact with skin occurs, rinse with warm water or dissolve
gradually with solvent such
as acetone, or nitromethane. Do not try to remove forcibly.
3.If adhesive gets into eye, keep eye open and rinse thoroughly.
Seek medical attention
4.Keep Solvent-free Ethyl Cyanoacrylate adhesive out of reach of
5.Keep adhesive in a cool, dry place 20-25ºC (68-77oF). For
long-term storage, refrigeration
(2oC or 35oF) is recommended.