Low Odor / Low Blooming Cyanoacrylate Adhesive Transparent Raw Glue
Ethyl Cyanoacrylate Raw Glue
Color: Transparent,colorless to yellowish
Container: Plastic bucket
Glue Type: Instant adhesive
Net weight: 20kg / 25kg
Low odor low blooming cyanoacrylate adhesive Raw Glue is different
from normal cyanoacrylate adhesives. Because Normal cyanoacrylate
adhesives tend to have a somewhat irritating odor and when used in
high moisture environments, there tends to be a whitening or
blooming phenomenon occurring on the sides of the attached parts.
This series of Low blooming low odor cyanoacrylate adhesive is of
high purity, with low odor and low blooming features. They are
specially designed for use where product appearance is desired, for
example, electrical components and automotive applications.Low odor
low blooming cyanoacrylate adhesive is also suitable for
applications where vapor control is difficult.
|Color||Transparent, colorless to Straw colored liquid|
|Specific Gravity @ 25ºC||1.06|
|Refractive Index (n D 20)||1.439|
|Vapor Pressure (hPa)||< 1|
|Viscosity (cP) ,25℃||4 – 15|
|Steel to Steel||20 – 70 seconds|
|Stainless Steel||30 – 60 seconds|
|Aluminum||5 – 20 seconds|
|Zinc plated||60 – 150 seconds|
|ABS to ABS||15 – 50 seconds|
|ABS to NBR||5 – 10 seconds|
|NBR to NBR||5 – 10 seconds|
|Polycarbonate||15 – 50 seconds|
DIRECTIONS FOR USE:
1. Make sure the surfaces to be bonded are clean and dry
(preferable to solvent-wipe plastics, glass, and rubber, and to
2.Dispense a drop or drops to one surface only. Apply only enough
to leave a thin film after compression.
3.Press parts together and hold firmly for a few seconds. Good
contact is essential. An adequate bond develops in less than one
minute. (Maximum strength is achieved in 24 to 48
4.Wipe off excess adhesive from the top of the container and recap
if left uncapped, may deteriorate by contamination from moisture in
Keep products in the unopened container in a cool and dry location.
Best when stored at 2 to 8ºC. Temperatures less than 2ºC can
adversely affect product properties. Do Not Freeze. Keep container
tightly closed until ready for use.
Material removed from containers may be contaminated during use. Do
not pour back any product to the original container. Misuse of
product will void all warrantees.
1.Use with proper ventilation. Avoid contact with skin and eyes.
2.If contact with skin occurs, rinse with warm water or dissolve
gradually with solvent such
as acetone, or nitromethane. Do not try to remove forcibly.
3.If adhesive gets into eye, keep eye open and rinse thoroughly.
Seek medical attention
4.Keep well out of reach of children.
5.Keep adhesive in a cool, dry place 20-25ºC (68-77oF). For
long-term storage, refrigeration
(2oC or 35oF) is recommended.