Surface Insenstive Ethyl Cyanoacrylate Raw Adhesive Solvent Free
Ethyl Cyanoacrylate Raw Adhesive
Container: Plastic bucket
Glue Type: Instant adhesive
Net weight: 20kg / 25kg
Surface Insensitive Cyanoacrylate adhesive is a quick setting
cyanoacrylate adhesive, specially formulated for bonding dry,
porous and acid surfaces, such as wood, paper made products, PU
foam, cork, rubber, and ceramics. It is specifically formulated for
the assembly of difficult to bond substrates, particularly suitable
for bonding plastic or rubber parts, where very fast fixturing is
required. Surface insensitive cyanoacrylate is suitable for
continuous or automated production lines,rubber and EPDM materials.
|Specific Gravity @ 25ºC||1.05|
|Vapor Pressure (hPa)||< 1|
|Viscosity (cP) ,25℃||15 -30|
|Steel to Steel||10 – 20 seconds|
|Stainless Steel||30 – 60 seconds|
|Aluminum||2 – 10 seconds|
|Zinc plated||30 – 90 seconds|
|ABS to ABS||2 – 10 seconds|
|ABS to NBR||3 – 5 seconds|
|ABS to Wood||5 – 10 seconds|
|NBR to NBR||2 – 10 seconds|
|Polycarbonate||15 – 50 seconds|
DIRECTIONS FOR USE:
1. Make sure the surfaces to be bonded are clean and dry
(preferable to solvent-wipe plastics, glass, and rubber, and to
2.Dispense a drop or drops to one surface only. Apply only enough
to leave a thin film after compression.
3.Press parts together and hold firmly for a few seconds. Good
contact is essential. An adequate bond develops in less than one
minute. (Maximum strength is achieved in 24 to 48
4.Wipe off excess Surface insensitive Cyanoacrylate adhesive from
the top of the container and recap if left uncapped, may
deteriorate by contamination from moisture in the air.
Keep products in the unopened container in a cool and dry location.
Best when stored at 2 to 8ºC. Temperatures less than 2ºC can
adversely affect product properties. Do Not Freeze. Keep container
tightly closed until ready for use.
Material removed from containers may be contaminated during use. Do
not pour back any product to the original container. Misuse of
product will void all warrantees.
1.Use with proper ventilation. Avoid contact with skin and eyes.
2.If contact with skin occurs, rinse with warm water or dissolve
gradually with solvent such
as acetone, or nitromethane. Do not try to remove forcibly.
3.If adhesive gets into eye, keep eye open and rinse thoroughly.
Seek medical attention
4.Keep well out of reach of children.
5.Keep adhesive in a cool, dry place 20-25ºC (68-77oF). For
long-term storage, refrigeration
(2oC or 35oF) is recommended.